?

Log in

No account? Create an account
Previous Entry Share Next Entry
still home
truck
soopageek
uess what? I'm still at home.

After finally getting better from my sinus infection, I went-out Monday morning to start the truck and... nothing. All the sitting had weakened the batteries so that it wouldn't turn the motor. Welf had already gone to work, so I was stuck. When she got home that night, I jump-started the truck from her car and let it idle for a little while then shut it down again. My intention was to get up early on Tuesday morning and jump it from the car before she went to work. It takes a good 30 minutes of charging over the cables to get enough juice to turn the motor sufficiently.

But I set the alarm incorrectly and didn't get up early enough before Welf had to leave for work. So I wrote Tuesday off, too. Wednesday morning though, I got the truck started and Welf went to work. I got in touch with dispatch and they assigned me a load bound for Colorado. After loading the truck with all my gear I pulled out of the drive-way. The truck shuddered and hopped around. I fiddled with the inter-axle differential lock some, thinking that I was slipping around in leaves in the driveway. The hopping started and I took off down the street. But something wasn't right. I stopped at the end of the street and got out, looking the truck over. Nothing looked awry.

I made my way out of the maze of suburban streets and pulled onto the highway. Once getting it up to a high speed, I saw smoke coming the rear tires. I raised-up in my seat and could see that the rear right drive axle wasn't turning. I stopped the truck again. Both tires on that axle were no flat.

Since the tires were already fucked, and rather than sit on the side of the highway for a couple of hours waiting for the tow truck, I drove it back to the house and parked on the street. I called my local truck shop and had them come get her. The brake on that axle had "cammed over" for some reason. I'm no mechanic, so I can't tell you precisely what this means. The brake linings were getting thin on all of the drive axles and this was likely a contributing factor.

So now the truck is the shop, getting new drive axle brakes all the way around, plus two new drive tires. The mechanic called me this afternoon and sound that there was a crack on in the left steer wheel, so I told him to go ahead and take care of that as well. He said he had a couple of drive tires there that had about the same tread on them as the other 6, so I'm having him put those on. He told me it should be ready around 10AM tomorrow. I'm going to have Welf take me to there in the morning before she goes to work and wait around the garage until it's done. Tomorrow will make three weeks that I've been home. I've got to get back on the road. The lack of income and this unexpected expense will make things financially dire real quick-like if I don't.
Tags:


  • 1
Camming over is a term for the way the breaks work, inside the drum is an S cam, named because it's shaped just like a S...

when applying the breaks the S rotates and expands the break shoes, because your lining was wearing thin, it allowed the S cam to go past the ends of the S think of it like such

break pad - S - break pad

turn the S sideways and it takes up more space, thus expanding the shoes, if thin the cam goes past the ends and gets trapped sideways and has the breaks applied all the time.

All in all it doesn't seem like it caused too much damage though.

Yeah, that's pretty much how my mechanic explained it. It's still all Greek to me. As far as damage goes, I did needlessly screw-up two drive tires that I probably could've gotten another 50-100k miles out of. :(

I answered tpbrcombo and essentially you as well, with this comment about jump starting from a car and drive tires. :)

  • 1